The Judge Die "Pro" Model for Automation

The Judge Die Pro model is for automated loader users to automatically sense certain incorrect caliber or problematic brass in their shell-plate.


The Judge Die Pro hooks directly up to the "Yellow" or "Blue" port on your AmmoBot machine where it intelligently senses certain types of brass that should not be in the machine. Plugging into the "Yellow" port will stop the machine upon engaging the sensor. Plugging into the "Blue" port will allow the press to complete the cycle and stop on the upstroke for allowing ease of removal, then pressing the "Green" button on the AmmoBot will allow the press to continue its cycle. For other automation, it will need to attached to whatever "stop" port is available. Mark 7 users can purchase an adapter cable, the ATMC, from us separately.


The Judge Die Pro, coupled with the AmmoBot Case Extractor works flawlessly to extract many types of unwanted brass from your shell-plate. While using the Judge Die with the AmmoBot Case Extractor, you will need a splitter on the blue port for this to function properly.


While set up for 9mm, the Judge Die senses:

Stepped brass(Maxxtech, etc)
7.62x25 bottleneck cases
38 Super
Debris in the case
Crushed case mouths

When set up for 40 S&W, the Judge Die senses:

10mm
357 Sig
Debris in the case
Crushed case mouths

When set up for 38 Special, the Judge Die senses:

357 Magnum
Debris in the case
Crushed case mouths

When set up for 44 Special, the Judge Die senses:

44 Magnum
Debris in the case
Crushed case mouths