Immortobot ™ Case Feeder Leg Extension

THIS ITEM IS PRINTED ON DEMAND. BACKORDER MEANS IT GOES INTO THE PRODUCTION QUEUE.

The Immortal Arms ™ ImmortoBot Case Feeder Leg Extension (CFLE) provides a solid base for the case feeder pole after the installation of the AmmoBot base.

The case feeder pole is not supported by the bench when the 1050 is installed by itself as it "floats" just above the bench surface. The pole is lifted 6" above the bench when an AmmoBot is installed. When the case feeder is full of brass and running, this can lead to vibrations of the entire press; toppling bullets, making cases shake as they come into station, etc.

These are printed in PLA, which provides them strength and a slight flexibility to help absorb and vibrations of the pole.

The top is a three sided "cup" and the floor of the tower is slightly higher than the bottom of the pole to allow the pole to seat itself into the material when installed.

Installation requires the removal of the lower bolt from the pole to allow the pole to rotate back slightly. This provides the clearance necessary to slide the CFLE into place (may require you to angle it slightly). When seated, rotation of the pole back to vertical compresses the pole into the tower. Reinstall the bolt and tighten.

NOTE: The base does not have the large holes you see in this picture. It is solid like the one in the background. If you wish to screw or bolt the base to your bench you will need to drill through the material.