Something new is on the way!

Immortal Arms Improved Swage Yoke (I2SY)


Add to Cart:

  • Description
  • Details
  • Reviews
The Immortal Arms Improved Swage Yoke (I2SY) provides a better way of accessing the 1050/1100/CP2000 swage rods. With the current single piece design that comes with the machine, accessing the the swage rod to change out the size, or to install a primer pocket sensor, can be a frustrating chore on automated machines.

The limited space between the drive wheel and frame on automated machines forces the operator to manipulate the drive to work the swage eye free of the original yoke, and then manipulate it around to allow the rod or probe to be removed from the machine. Installation is just as laborious.

The I2SY, allows the yoke to be completely removed or installed with just two bolts that hold the haves together. This makes the process extremely simple and quick.

The I2SY replaces the following parts:
13840 Cotter pin
13522 Clevis pin
13064 Swage cover
13896 1/4-20 3/8" bolt (x2)
13417 Swage connecting rod
13581 Grease fitting (not needed with the two piece design)

The yoke is made from 4140 steel. You may want to lay a light layer of oil or grease on the surface if your press or dies are prone to rust. The cover plate is made from aluminum.
  • Model: I2SY
  • -7 Units in Stock
  • Manufactured by: Immortal Arms

Be the first to write a review.  Write a Review.



Is $2100 a lot of money to you? It is to us. That is how much you save with the ImmortoBot system over the competitors offering.

MinBot Rev 2 finally available